What are my options on putting the or2800 into a Rohn 25? When I bought it, someone there said I had to remove a cross brace. If I do that in a regular section, will the rotator fit? Appreciate heari
Steve As per M^2's Orion 2800PDC manual: "The Rohn 25G tower is the smallest that will accept the OR-2800PDC positioner and only in the top section that tapers into a mast guide-tube. The positioner
I have not installed one of these...but it sounds like it might be a candidate for installation at the top of the second section of tower down... the top of the section is the tapered end of the tube
Getting the M2 2800 inside Rohn 25G at any spot other than the open area at the top of a top section requires substantial modification of the tower. I tried it last year, but I felt that cutting out
An OR2800 M2 rotator can be squeezed in at the bottom of the top section of Rohn 25 by removing the lowest horizontal brace from one side. This leaves enough space to slide the rotator inside with a