I have a homebrew 8877 that runs about 40- 50 ma.
grid current at 1 amp plate current with a plate voltage of
about 3100 volts, and from what I understand that is about right.
Sounds like the meter is reading about double true current assuming
the tube is good.
Mark WB8JKR
On Sat, 23 Jan 1999 13:28:11 -0800 dan hearn <dhearn@ix.netcom.com>
writes:
>
>I have a single tube Alpha 77DX. The instruction book says "The 8877
>is
>extremely rugged and operates with a large safety margin if grid
>current
>is never allowed to exceed 0.2 amperes, nor plate current 1.0 amperes
>per tube." It also says" monitor drive power adjustment so that
>amplifier grid current remains in the range of 0.1-0.15 ampere for the
>77DF/77DX versions" They specifically state that these values apply to
>the single tube version.
> The grid current meter is labeled 500 ma full scale. A study of the
>resistors in the grid current measuring circuit tells me that it may
>actually be 250ma full scale. In order to obtain legal limit output ,
>a
>grid current of at least 100 ma indication on the meter (assuming 500
>ma
>f.s.) is needed. Eimac's data sheet for the 8877 shows a lot less grid
>current for 1500w output. Can anyone throw some light on this
>situation?
>Thanks, Dan, N5AR
>
>
>--
>FAQ on WWW: http://www.contesting.com/ampfaq.html
>Submissions: amps@contesting.com
>Administrative requests: amps-REQUEST@contesting.com
>Problems: owner-amps@contesting.com
>Search: http://www.contesting.com/km9p/search.htm
>
>
___________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com/getjuno.html
or call Juno at (800) 654-JUNO [654-5866]
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|