Amps
[Top] [All Lists]

[AMPS] PS diode equalizing

To: <amps@contesting.com>
Subject: [AMPS] PS diode equalizing
From: n2bc@stny.rr.com (Bill Coleman)
Date: Sat, 3 Jul 1999 12:53:21 -0400
Hi Vic, from 1996 ARRL Handbook, DIODES IN SERIES, page 11.9:

"There used to be a general recommendation to place a resistor across each
diode in the string to equalize PIV drops. With modern diodes, this practice
is no longer necessary."   It goes on to explain why then concludes with:
"In fact, shunt resistors can actually create problems..." and why again.

The 1N5408 qualifies.  I use 16 of these in each leg of a fullwave putting
out 4KV - no probs.

73, Bill  N2BC

-----Original Message-----
From: Vic Rosenthal <rakefet@rakefet.com>
To: Amps reflector <amps@contesting.com>
To: <amps@contesting.com>
Date: Saturday, July 03, 1999 11:49 AM
Subject: [AMPS] PS diode equalizing


>
>What's the current view on equalizing caps and resistors across diodes in
>rectifier strings?  The ARRL handbook says you should put a 0.01 mf
capacitor
>and (I think) 1000 ohms per volt resistor across each diode.  I dimly
recall a
>discussion in which this was said to be *not* advisable.  I'm using 5
1N5408's
>per leg of a fwb with 2400 vac input.
>
>73,
>Vic, K2VCO
>Fresno CA
>
>--
>FAQ on WWW:               http://www.contesting.com/ampfaq.html
>Submissions:              amps@contesting.com
>Administrative requests:  amps-REQUEST@contesting.com
>Problems:                 owner-amps@contesting.com
>Search:                   http://www.contesting.com/km9p/search.htm
>
>


--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>