I just noticed that the filament transformer I was planning to use (got it free)
for my 2 x 3-500z amp does not have a center tap. It has two 5v 20a windings
which I was going to put in parallel.
I recall that sometime back there was a thread on the subject of how to simulate
a center tap on a filament transformer that doesn't have one. Does anyone
remember the (haha) consensus of opinion on this?
What would happen if I just connected the b- return to one side (don't shoot me,
I'm just asking)?
73,
Vic, K2VCO
Fresno CA
--
FAQ on WWW: http://www.contesting.com/ampsfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|