They look like flat mica matching capicators to me.
Check the Motorola RF Devices manual and you will see them in a lot of their
test circuits. They typically put two in parallel to reduce the inductance.
One manufacturer is Mini-Underwood or Mini Unelco.
73, Harry, W3IIT
At 11:24 AM 04/03/2000 EDT, KA1MIACT@aol.com wrote:
>
>I have uploaded a picture of a part to our website; There are allot of them
>on the amplifier board. Can anyone tell me what they are? They are
>installed on a Falcon Communications amplifier board.
>
>
>the page is <<A
>HREF="http://www.qsl.net/kb1bzp/falquestion.htm";>http://www.qsl.net/kb1bzp/fal
>question.htm<</A>
>
>--
>FAQ on WWW: http://www.contesting.com/ampsfaq.html
>Submissions: amps@contesting.com
>Administrative requests: amps-REQUEST@contesting.com
>Problems: owner-amps@contesting.com
>Search: http://www.contesting.com/km9p/search.htm
>
>
>
<center>Microwave Update/Hamarama 2000
September 28, 29, 30/October 1, 2000
PHILADELPHIA, PA.
FOR INFORMATION VISIT
</center> http:// www.ij.net/packrats/mud.html
--
FAQ on WWW: http://www.contesting.com/ampsfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|