> I pulled a recent aquisition apart (Henry 2kd Classic) because my
> line current here is 244 volts. Reading the manual I received with it
> it seemed it was going to be a simple task to change some of the taps
> and make the amp happy with the voltage. Unfortunately, it appears I
> (perhaps) have a newer schematic than I have hardware. The manual and
> schematic refers to an ECA 1120A HV transformer and the amp has an
> ECA 1120 which has far fewer taps than the schematic indicates.
I have run across the same problem several times.
The folks at ECA have always been most helpful in letting
me have the specs and tap data on their transformers and
chokes. I think they are still in the Los Angeles area.
(((73)))
Phil, K5PC
|