Amps
[Top] [All Lists]

[Amps] Copper Pi tank coil oxidisation

To: <amps@contesting.com>
Subject: [Amps] Copper Pi tank coil oxidisation
From: 2@mail.vcnet.com (Richard)
Date: Wed, 8 May 2002 08:38:04 -0700
>Hi
>
>I'm in the commissioning and measurement stages of my homebrew 
>4CX1000A amp project (1600W out now and looking good).
>
>A couple of weeks have passed by since I wound the Pi tank coils
>using 5mm Cu tubing. Since then the copper has gone from shiny
>to dull brown by oxidation.
>
>Does this matter very much? I guess the RF skin resistance won't 
>be affected very much to affect HF efficiency.
>
?  not much but to prevent Cu O from forming, polish the tubing with fine 
steel wool and coat with gloss urethane varnish.

>Are there any recommendations for coating Cu tube to keep it 
>shiny and is it worth it (for more than cosmetic value)? 
>
>73 Mark G4AXX
>
>
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
>


-  R. L. Measures, a.k.a. Rich..., 805.386.3734,AG6K, 
www.vcnet.com/measures.  
end


<Prev in Thread] Current Thread [Next in Thread>