Mike,
I recently reworked a DTR-2000 amp, although I do not have the amp any
longer here are my observations.
> Q1) I was wondering if some of the other DTR-2000 owners out there might
be
> able to tell me what their input SWRs is like and what it may range on the
> some of the bands.
80 meters -1.5 to 1
17 meters - 3 to 1 (used the rig's internal tuner help)
By the way, the RF choke from RF Parts is a great replacement and solves the
choke issues with the amp. Sells for about $23..
> Q3) In the SSB position, I noticed the bias on the 8877 is down around
50ma.
> I recall that it used to be around 180ma and I not sure if it changed or
> something else if going on. What's the experts consensus on where idle
bias
> should be with a meager 2700V B+ on the anode?
The DTR-2000 idled at 50 ma. So does my other 8877 amps. I did search the
Eimac Spec. sheet, but could not find any certain idle current for AB2,
cathode driven, just refernce to the 8.2 volts on the cathode via a zener..
Hope this helps,
Thanks and 73's,
Dudley
WA5QPZ
jhurry@austin.rr.com
----- Original Message -----
From: "Mike Krzystyniak" <k9mk@flash.net>
To: <amps@contesting.com>
Sent: Sunday, October 20, 2002 10:58 AM
Subject: [Amps] Dentron DTR-2000
> I recently pulled my DTR-2000 out of semi retirement and aside from
some
> dust and a little stiffness in the tuning caps she fired up just fine.
>
> While tuning up for a 20M QSO (driven from my FT-1000 into a dummy
load)
> I noticed the input SWR was not even close to 1:1. Not that I am
surprised
> by this as this amp has no tuned input so I expected that. But the SWR
was
> higher than I recall it being and was in the range of >2:1 and <3:1.
Maybe
> something did break...
>
> Q1) I was wondering if some of the other DTR-2000 owners out there might
be
> able to tell me what their input SWRs is like and what it may range on the
> some of the bands.
>
> Q2) Besides going to a tuned input are there are any methods to help
> stabilize the SWR to something closer to 50 ohms?
>
> Q3) In the SSB position, I noticed the bias on the 8877 is down around
50ma.
> I recall that it used to be around 180ma and I not sure if it changed or
> something else if going on. What's the experts consensus on where idle
bias
> should be with a meager 2700V B+ on the anode?
>
> Thanks!
>
> Mike K9MK
>
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
|