Now, I know this is ALEX.
RF power switching in 1.6nS?????
And what devices are you going to use that will not also produce distortion and
harmonic generation.
73
Bill wa4lav
At 09:09 AM 11/15/02 -0500, mark wrote:
>HS is possible if you detect the Zero Crossing of the Carrier and your
>switch can close
>under %5 of the Cycle time. With a SS switching system it is quite possible
>even at 30MHz
>Mark
>
>
>
>----- Original Message -----
>From: "Jim Reid" <jimr.reid@verizon.net>
>To: <amps@contesting.com>
>Sent: Thursday, November 14, 2002 11:10 PM
>Subject: [Amps] Hot Switching
>
>
> > Ok, is it possible to hot switch the amp when
> > using the SSB mode? I don't think so, unless you
> > "switch" right in the middle of a loud vowel sound?
> > Correct?
> >
> > 73, Jim KH7M
> >
> >
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
|