In a message dated 2/10/05 6:21:53 PM Central Standard Time,
crazytvjohn@yahoo.com writes:
I am in the process of developing a means of notching plastic rod for coil
spacing retainers using my shopsmith, cuts a notch in 1/4"rod to half
thickness about 1/8 inch apart. This will give with #10 wire about 10 turns
per
inch.
If the cuts are 1/8 inch apart; wouldn't that give you 8 turns per inch?
I have successfully used superglue to 1KW, but have not tried it with higher
power levels.
Dennis O.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|