Dan -
It is my understanding that the RF-1 displays just the magnitude of the
impedance vector. It cannot directly separate the resistive and reactive
elements into R + jX. Instead, it reads !Z! or the square root of the sum of R
squared and X squared. When you measure a pure 50 ohm resistance, the
reactance is zero and the Z (what you read) is 50. When you press the C
button, you get the value of capacitor that will yield that magnitude of
impedance at the selected frequency. Likewise when you press the L button.
To be clear, you cannot directly read resistive, capacitive or inductive
components of a complex impedance on the meter unless there is a pure
resistance, capacitance, or inductance.
That said, I believe the website has a set of equations from which R + jX can
be derived from the Z and SWR measurements. This is not in the manual.
Hope that helps a little
73, Tom W2SC
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com]On
Behalf Of Dan Sawyer
Sent: Saturday, February 26, 2005 1:17 PM
To: amps
Subject: [Amps] close to off topic - how to read antenna R + jX ??
All,
I have become interested in leaning more about what is actually going on
at the antenna. I have a vertical and would like to measure it.
First I have an Autek RF-1. It measures swr, Z, L, and C at a preset f.
I am not certain what the L and C are reading. When I measure a 50 Ohm
terminator at 7.2 MHz it actually reads a Z of 50 and an SWR of 1.0.
However the L and C readings are of 2 uH and 2500 pf. What are these
actually measuring? The values are very close to those from the antenna.
How can I actually measure the L and or C component of the antenna? If I
use an impedance bridge at the frequency will it measure L (or C)?
I hope this is close enough to topic.
Dan
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|