In a message dated 16/04/2005 21:18:09 GMT Standard Time,
garyschafer@comcast.net writes:
But you must be able to disable the agc or it won't work.
You must also make sure that the receiver audio dynamic range is sufficient.
F'r instance, if the the AF output is set to 50mW without the amp, it must
do at elast 500mW without gain compression when the amp is on - if the amp
gives 10dB of gain. If it gives 20dB, then you need an uncompressed AF output
capability of 5 watts.
Once had to deal with an applications complaint from a professional (?) lab
where they made that mistake when trying to measure sensitivity.
73
Peter G3RZP
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|