Amps
[Top] [All Lists]

Re: [Amps] Building or Buying a Tuned Input Network

To: k6zz@ccis.com, amps@contesting.com
Subject: Re: [Amps] Building or Buying a Tuned Input Network
From: Hector Garcia XE2K <j_hector_garcia@sbcglobal.net>
Date: Sun, 22 Jan 2006 19:33:15 -0800 (PST)
List-post: <mailto:amps@contesting.com>
Bob:

this option works for you ?

http://home.earthlink.net/~wd7s/TU-6B.htm
i found it several monts ago for the idea to add to
the MLA2500


--- "Bob Selbrede, K6ZZ" <k6zz@ccis.com> wrote:

> Hi Folks,
> 
> I would like to build or buy a tuned input network
> (160M-10M) for an amp running a pair of 3CX800A7's. 
> Here
> are my thoughts so far.  Comments appreciated.
> 
> Buy:
> 
> So far, I haven't found anyone on the web building
> and
> selling tuned input networks suitable for this
> application. 
> I could probably just buy one of those LDG units
> that was
> mentioned on the AMPS List the other day, but it
> seems like
> overkill.  After the values for the input matching
> network
> are know and set, they most likely won't change so
> an
> autotuner seems to provide features that aren't
> really
> necessary.  Then again, for $125 maybe, it may be
> worthwhile
> in the long run.
> 
> Another thought would be to buy a tuned input board
> for an
> existing commercial amplifier such as the Ameritron
> AL-800H.
>  I'm not sure how much it would cost, but it runs a
> pair of
> 3CX800A7's so it would most likely work fine.
> 
> Are there other "buy" alternatives?  I called Omega
> Electronics and they apparently don't have any more
> tuned
> input boards on hand.
> 
> Build:
> 
> Building a tuned input network seems pretty
> straightforward.
>  A switchable PI network with tunable slug inductors
> seems
> like a good approach.  I'm assuming that the input
> impedance
> for the tubes would be approximately 25 Ohms so I
> would be
> looking at matching 50 Ohms to 25 Ohms from 160M
> through
> 10M.  Shooting for a Q of 2-4 I should be able to
> use a PI
> network calculator to get the proper component
> values. 
> Sound about right?
> 
> Another approach would be to build the network
> utilizing the
> same component values as used in the AL-800H or
> other 2x
> 3CX800A7 amplifier input circuit?
> 
> Am I overlooking any other build/buy alternatives?
> 
> 73, Bob K6ZZ
> 
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
> 


Hector Garcia XE2K / XF1K
Mexicali B.C  DM22
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>