Amps
[Top] [All Lists]

Re: [Amps] TL922-one tube dead?

To: <HB9CVQ@hispeed.ch>
Subject: Re: [Amps] TL922-one tube dead?
From: "Hsu" <Jbenson@sohu.com>
Reply-to: Hsu <Jbenson@sohu.com>
Date: Sun, 10 Dec 2006 16:22:43 +0800
List-post: <mailto:amps@contesting.com>
Hi,
   I have 3-500C, $135/ea(less  than 10 piecs),  over 10 piecs, $ 125/ea.
 The 3-500C is same as RF parts's 3-500Z, same  factory's products,raphite
 anode.the shipping cost is only depend on the shipping way , weight and 
distance.
  I'll not charge additional cost. I have  sold some tubes in this refelector.
           73! Hsu
         
----- Original Message ----- 
From: "Andy Diethard Hansen" <HB9CVQ@hispeed.ch>
To: <amps@contesting.com>
Sent: Sunday, December 10, 2006 7:35 AM
Subject: [Amps] TL922-one tube dead?


> 
> 
> Hi Group,
> 
> My modified TL-922 (230V/50Hz) created some humming noise in the past month
> (may be filament transformer-somehow remaining after PA switched off) before
> going to half power after 15 years, yesterday. Some smell came from the amp.
> The noise now is very strong  when switched on and will reduce a little
> after a while.
> Looked from the outside first like some arcing on the board right next to
> the left upper corner. One tube is now not heating anymore (left from
> front). Grid Idle/plate current and power out are down to 50% normal in CW
> and SSB. HV is normal. I assume one tube has gone to heaven (matched
> pair?-3-500Z orig.)
> 
> Questions:
> 
> Where do I get quickly a reasonably priced (set?) of tubes and a
> FILAMENT Transformer???
> 
> Any other advice/comments/experience? tnx for help
> 
> Andy HB9CVQ
> www.qrz.com/hb9cvq
> 
> 
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>