LLoyd, I would suggest you use a different power meter on the output to
verify the accuracy of your measurements.
With 2500w+ input power and 300w output power, there is a loss of 2200W+. I
would expect to see the tube or some other component in melt down if this was
truly the case.
73,
Gerald K5GW
In a message dated 12/1/2008 6:15:26 A.M. Central Standard Time,
k8dio@windstream.net writes:
My original posting to the group was in regards to a problem I have with the
Al-1200 on 160 mtrs. I have since borrowed a Cantenna dummy load so I
could check the amp on other bands. My driver is a TS-2000 going through an
old
Kenwood antenna tuner. I am measuring 25 ma in CW and 125 ma in SSB positions
with no drive. My problem is that I am getting very low efficiency. Here
are some readings that I have taken:
Approximately 75 watts drive power
40 mtrs - CW position
Plate Volts = 3400 vdc
Ig = 200 ma
Ip = 750 ma
Power Output = 300 watts
Power Input = 2500 watts
160 mtrs - CW position
Plate Volts = 3400 vdc
Ig = 200 ma
Ip = 700 ma
Power Output 450 watts
Here are few things that I have tried from suggestions on the group:
I used my cap meter to check all of the padding caps. All of the doorknobs
and the small caps on the pc board checked okay.
I inspected the bandswitch contacts for signs of arcing.
I used a MFJ antenna bridge to check the ability of the amp to resonate. I
put a 2.7K resistor from plate to ground and fed the bridge into the coax
line at RFC 4. I calibrated the bridge with the Cantenna. All bands, except
80
and 160 meters gave me a deep null on the meter when I tuned the Plate and
Load controls.
I checked the 1N5408 diode on the capacitor board and that was okay.
The input swr is below 1.5:1 even without my tuner in line.
Can the tube be the problem??
Thanks,
73, Lloyd K8DIO
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
**************Life should be easier. So should your homepage. Try the NEW
AOL.com.
(http://www.aol.com/?optin=new-dp&icid=aolcom40vanity&ncid=emlcntaolcom00000002)
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|