Is this what your are looking for?
http://www.mcmaster.com/#j-bolts/=12rf23
73 n8dx
On Thu, Mar 19, 2009 at 8:48 PM, Carl <km1h@jeremy.mv.com> wrote:
> I gave up looking for the right sizes and make my own. A bit of steel, a
> shear and threaded rod. Roll the top and braze or weld on the rod. A bit
> of paint and youre done.
>
> Another way that comes to mind for a basic basement job is 3 aluminum,
> brass or steel strips, 2 for the sides and a top piece. Threaded rod top
> and bottom and some of that super strong epoxy.
>
> Carl
> KM1H
>
>
>
>
> ----- Original Message -----
> From: "Roger Parsons" <ve3zi@yahoo.com>
> To: "Amps" <amps@contesting.com>
> Sent: Thursday, March 19, 2009 7:50 PM
> Subject: [Amps] Clips for oil-filled capacitors
>
>
> >
> > After looking at the nice pictures of YC156 amplifiers, my mind
> > wandered to the large oil-filled capacitors. The capacitors themselves
> > are easy enough to get, but does anyone know of a source for the
> > mounting clips? (The ones that clip over the top edge of the capacitor
> > and are bolted to the chassis at the bottom.)
> >
> > Thanks
> >
> > Roger
> > VE3ZI
> >
> >
> >
> >
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|