Can you "really" cook a vacuum ??
I have never heard of a getter function being available.
Don WA4NPL
Quoting Carl <km1h@jeremy.mv.com>:
> This thread brings up a question Ive had for awhile. When hi potting a
> vacuum variable is it better to use AC or DC for the cooking?
>
> Ive a surplus shop commercial unit that goes to 15 kV in 3 ranges and with
> selectable current limiting. I havent used it for anything but testing
> transformer insulation so far.
>
> Carl
> KM1H
>
> ----- Original Message -----
> From: "Randall, Randy" <Randy.Randall@healthall.com>
> To: "'Steve'" <g8gsq@f2s.com>; <amps@contesting.com>
> Sent: Friday, September 18, 2009 9:51 AM
> Subject: Re: [Amps] Vacuum variable hipot
>
>
>> You should really see 0uA. Run it through its range and stop on the
>> positions that have leakage. Drop it to 4 KV and let it cook. You might
>> be able to effect a repair if it is gas as the arc will getter to some
>> extent or the arc may help clear the leakage path. It could very well
>> make it worse. You have nothing to lose at this point.
>>
>> Randy AB9GO
>>
>> -----Original Message-----
>> From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
>> Behalf Of Steve
>> Sent: Friday, September 18, 2009 7:03 AM
>> To: amps@contesting.com
>> Subject: [Amps] Vacuum variable hipot
>>
>> I have a Jennings UCSL1000 - 1000pF, 5kV cap. If I put 5kV dc across it
>> and run it through its tuning range, the leakage current is sometimes
>> zero but fluctuates and there are places where the current leaps up to
>> 50uA. At those points the current falls to zero if the voltage is
>> reduced to around 4kV, although I have heard a couple of arc 'pops' from
>> it sitting there at 4kV.
>>
>> At other settings where the current is lower, 5uA or less, the leakage
>> dies away to zero if I leave it sitting there for a while.
>>
>> Is this normal behaviour? Is this one a duffer?
>>
>> Thanks,
>>
>> Steve
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
>> Confidentiality Notice: This e-mail message, including any attachments, is
>> for the sole use of the intended recipient(s) and may contain confidential
>> and privileged information. Any unauthorized review, use, disclosure or
>> distribution is prohibited. If you are not the intended recipient, please
>> contact the sender by reply e-mail and destroy all copies of the original
>> message.
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|