Amps
[Top] [All Lists]

Re: [Amps] HV ripple voltage

To: Carl <km1h@jeremy.mv.com>
Subject: Re: [Amps] HV ripple voltage
From: Roger <sub1@rogerhalstead.com>
Date: Sat, 07 Nov 2009 23:10:16 -0500
List-post: <amps@contesting.com">mailto:amps@contesting.com>

Carl wrote:
>
>> If the no load voltage for a 3cx800A7 amplifier's power supply is 2500 V, 
>> while the fully loaded voltage is 2100 V @ 1A, is that "good"? Is it good 
>> enough?
>>     
>
>
> Its better than a SB-220 and about the same as many other amps. A 10% 
> regulation is considered the benchmark but its seldom met when pricing 
> competition is stiff. On SSB with a 30% duty cycle (no processor) the 
> dynamic regulation will be much better.
>   
If building I prefer better, but that's about the kind of regulation on 
most of my amps.  It's an area of rapidly diminishing returns. More 
iron, more copper, more capacity, and lots more money for an increase 
most would never notice in operation.
> If that is 8 @ 330uF that gives a 41uF filter which is very good. I dont 
> have the books open (heading to bed) but that should give you around 1-2% 
> ripple. Heath, Alpha, Ameritron, etc use  less C. The effect is linear; 
> double the C and the ripple is cut in half.
>
> Carl
> KM1H zzzzzzzzzzzzzzzzzzzzzz
>
>   
Bed?  Carl, 10:50 is nigh onto the middle of the afternoon.  <:-))

73

Roger (K8RI)
>   
>> thanks,
>> Paul (KG7HF)
>>
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
>>     
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>   
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>