Carl,
Not sure myself. Both mods I have in the files were drafted by prior 70V
users but they look well-designed.
Paul, W9AC
.
----- Original Message -----
From: "Carl" <km1h@jeremy.mv.com>
To: "Paul Christensen" <w9ac@arrl.net>; <K8MLM@aol.com>;
<audioguy@charter.net>
Cc: <amps@contesting.com>
Sent: Wednesday, December 30, 2009 9:08 AM
Subject: Re: [Amps] Alpha 78 Problem
> Im aware of that part Paul. I was referring to a fix that allowed the EBS
> to still be used. Its been a long time and I dont remember the details but
> it didnt come from Alpha. It might have been in HRM as that was about the
> only technical mag at the time.
>
> Carl
> KM1H
>
> ----- Original Message -----
> From: "Paul Christensen" <w9ac@arrl.net>
> To: <K8MLM@aol.com>; <km1h@jeremy.mv.com>; <audioguy@charter.net>
> Cc: <amps@contesting.com>
> Sent: Wednesday, December 30, 2009 7:58 AM
> Subject: Re: [Amps] Alpha 78 Problem
>
>
>>> When the 77 was still in regular use it was easy to spot one by the
>>> splatter
>>> caused by the electronic bias spike. There has been a lot written about
>>> a
>>> fix.
>>
>> I spoke with Ray Heaton about this back when I purchased my first 77Dx.
>> On the Dx/Sx models, the EBS can be defeated by adjusting one
>> potentiometer on the bias board. Plate idling current can be adjusted to
>> reasonable levels and the added heat produced when the key line is pulled
>> low is never a problem.
>>
>> By contrast, my Alpha 70V uses a fixed EBS system and when signal
>> strength on the Rx end is very strong, artifacts from the EBS can
>> certainly be heard. I have two different modifications for this but
>> decided to leave the original EBS intact, at least for now.
>>
>> Paul, W9AC
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|