ORIGINAL MESSAGE:
On Wed, 13 Jan 2010 04:22:06 -0800, "Jim Thomson" <Jim.thom@telus.net> wrote:
> Broke off at the RF deck end,
>and laid on the carpet, behind the desk, with a myriad of other cables.
REPLY:
IMO, the best approach is to NOT use a connector at the RF deck end. Just
hardwire the HV wire directly into the amp and put a connector at the power
supply end. Connectors are notorious for failing, just as above, and if done
this way, a connector failure will not expose any HV.
73, Bill W6WRT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|