Hi Bob,
That was me. I've been looking for a 1 mA (or less) meter for an amp
project, with dimensional requirements that it
1. fit in the circular hole, and
2. cover the extraneous holes that remain from earlier iterations of the
project.
It sounds like the meter you have would probably fill the bill. Would it
be possible to see a picture of the meter? Or better, one each of the front
and the back, so I can see how the barrel sits on the meter.
That would be very helpful.
Thanks very much!
Steve
Steve Gilbert
K1SG
K1SG@AOL.com
508-435-9133
FN42fe
In a message dated 6/30/2010 3:00:26 P.M. Eastern Daylight Time,
amps-request@contesting.com writes:
Message: 7
Date: Wed, 30 Jun 2010 11:23:55 -0700 (PDT)
From: Robert Groh <rgroh@swbell.net>
Subject: Re: [Amps] inquiry for a replacement panel meter
To: amps@contesting.com
Message-ID: <202076.87433.qm@web83815.mail.sp1.yahoo.com>
Content-Type: text/plain; charset=us-ascii
A couple of days ago someone posted looking for a replacement meter for a
(I assume) already built amplifier. At the time, I didn't have anything
that was close but I was just cleaning out and organizing and I found one
which might be close although I think it is a bit tall. I trashed the
original email hence this one.
My meter is from a early "multi-tester", i.e. I think it combined a tube
tester with a voltmeter and ohm-meter. Meter sensitivity unknown (although I
could measure it if needed) but I'm reasonably sure it is 1 mA FS or
better. It has a rectangular face about 4-5/8" wide x 4-1/8" tall and the
barrel
is 2-3/4" diameter. Case is black bakelite.
If anyone is interested, just give me a shout at <rgroh@swbell.net>
73
Bob Groh, WA2CKY
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|