Hi Vic
I checked that and even pushed them in a little so I could see them move out
a bit when the switch moved under them. Thanks and 73
Tom W7WHY
Take a very close look at the bandswitch contacts that are connected to
those switched caps.
On 2/8/2012 6:33 PM, Tom Osborne wrote:
> Hi All.
>
> I have a SB-200 and it developed a problem in the last week or so.
>
> When tuning up on 40, the Load cap is all the way meshed and the Tune cap
> is
> about 50% meshed. It puts out about 400 watts on 40. On 40, the input
> SWR
> is 1:1.
>
> In 80 the Load cap is all the way meshed. It puts out about 200 watts.
> The
> input SWR is 1:1.
>
> I checked to make sure the 2 sections of the Load cap were soldered
> together
> OK and they are. I disconnected the cap that is switched in on 80 and
> replaced it with another one and still doing the same thing.
>
> If the tubes are going soft, will it affect the tuning like that? Seems
> like I've replaced the tubes before but never had the problem of the Load
> cap being all the way meshed to load on 40. Thanks and 73
> Tom W7WHY
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|