Amps
[Top] [All Lists]

Re: [Amps] addendum to 8877 plate voltage post

To: amps@contesting.com
Subject: Re: [Amps] addendum to 8877 plate voltage post
From: "Roger (K8RI)" <k8ri@rogerhalstead.com>
Date: Sat, 30 Jun 2012 22:43:39 -0400
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Hmmmm... Me thinks some one should reset the year on their computer from 
2000 to 2012

73

Roger (K8RI)
On 6/30/2000 9:44 PM, Barrie Smith wrote:
> ----- Original Message -----
> From: "Tim Duffy K3LR" <k3lr@k3lr.com>
> To: "'Charles Bibb'" <zedkay@telepak.net>; <amps@contesting.com>
> Sent: Saturday, June 30, 2012 4:48 PM
> Subject: Re: [Amps] addendum to 8877 plate voltage post
>
>
>> Hello Charles:
>>
>> I have had no trouble running 4100 VDC for plate voltage on the 8877.
>>
>> There are guys that run close to 5 KV.
> Even Six!
>> 73,
>> Tim K3LR
>>
>> -----Original Message-----
>> From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
>> Behalf Of Charles Bibb
>> Sent: Saturday, June 30, 2012 4:37 PM
>> To: amps@contesting.com
>> Subject: [Amps] addendum to 8877 plate voltage post
>>
>>
>> Forgot to add this in my last post about high 8877 anode voltage:
>>
>> I've considered a "buck" transformer on the main transformer
>> primary.  I only need to "buck" the input a few volts (less than 20).
>>
>> Is this worth the trouble?  Or should I just run it a tad high?
>>
>> 73,
>> Charles - K5ZK
>>
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>



_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>