On 2/18/2013 4:27 PM, Bill Coleman wrote:
Disregard! Younger fingers than mine have prevailed!
Although you've solved the problem I though I'd throw this out in case
some one else might have this problem.
Try one of the thin rubber disks used to get a better grip when opening
jars with the screw on tops.
73
Roger (K8RI)
From: Bill Coleman [mailto:n2bc@stny.rr.com]
Sent: Monday, February 18, 2013 3:14 PM
To: amps@contesting.com
Subject: 4CX1000 removal
The tube anode cooler is only about ¼” above the chimney. I cannot get
enough grip to rotate the tube. Removing the chimney is almost out of the
question – lots of other stuff is in the way.
I’m thinking about making a tool that I clamp on the center anode post to
give me some leverage.
Any reason to not apply rotational force to the post??
THANKS – and other ideas welcome! 73, Bill N2BC
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|