That's exactly my technique too. The thought of using a fly cutter fills me
with terror, they look to be about the most ill-thought-out dangerous tool
imaginable. I think they're actually designed to allow potential users to
select themselves for a Darwin Award.
Dave G0OIL (complete with all fingers ... just about)
________________________________
From: Vic K2VCO <k2vco.vic@gmail.com>
To: amps@contesting.com
Sent: Friday, 13 September 2013, 16:36
Subject: Re: [Amps] Workshop Danger
I have a drill press with speeds ranging from fast to escape velocity. I've
given up on
hole saws, and admit that I've gone back to drilling several 3/8" holes around
the
periphery, joining them with a jigsaw, and finishing up with a file.
The last picture on my 4CX100A amp page
<http://www.qsl.net/k2vco/4CX1000A/K2VCO%204CX1000A%20Amplifier.html>
shows a panel with some meter holes made with this method.
On 9/13/2013 5:24 AM, Jim Garland wrote:
> My least favorite part of homebrewing an amplifier is making the meter
> cutouts and tube socket holes. Last evening I cut three 2.90 holes for
> GU-74Bs and survived the experience. I have a set of hole saws, but not
> metric ones for Russian tubes, and therefore had to use a fly-cutter. IMHO,
> fly-cutters are the most dangerous tool in a workshop. I hate the things. I
> securely clamped the sheet aluminum stockl to the bed of a large
> (floor-mounted) drill press, set the drill press on its slowest speed, and
> used aluminum cutting fluid. One has to advance the fly-cutter VERY slowly
> to prevent the cutting tool from grabbing the aluminum. If that happens, the
> sheet aluminum is likely to go flying around in a big circle like a sythe.
> The other danger is absent-mindedness, which can lead the drill press
> operator to reach in with his fingers to remove a piece of aluminum debris.
> Fly-cutters should never be used with a hand drill, as I stupidly tried once
> as a teen-ager. They absolutely require a large floor-mounted drill press
> with a sizeable bed.
>
>
>
> 73,
>
>
>
> Jim Garland W8ZR
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
--
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|