Amps
[Top] [All Lists]

Re: [Amps] HV fuses

To: "Fuqua, Bill L" <wlfuqu00@uky.edu>
Subject: Re: [Amps] HV fuses
From: MU 4CX250B <4cx250b@miamioh.edu>
Date: Thu, 24 Oct 2013 23:48:40 -0600
List-post: <amps@contesting.com">mailto:amps@contesting.com>
It didn't sound right to me either, Bill. The seller provided no data
sheets other then claiming a 900 mA/5kV rating for the fuses. I think
they were intended for microwave ovens, but am not sure. As I said, I
bought them out of curiosity because they were so cheap.

Sent from my iPad

> On Oct 24, 2013, at 23:38, "Fuqua, Bill L" <wlfuqu00@uky.edu> wrote:
>
>   This does not sound right. I assume you are saying that they are glass 
> fuses.
> I suspect if you blow one in a HV powe rsupply it will shatter or explode 
> into pieces if
> you have a reasonable value of filter capacitor.  Do you have a data sheet on 
> these
> fuses?
> 73
> Bill wa4lav
>
> ________________________________________
> From: Amps [amps-bounces@contesting.com] on behalf of Jim Garland 
> [4cx250b@miamioh.edu]
> Sent: Thursday, October 24, 2013 7:58 PM
> To: Amps@contesting.com
> Subject: [Amps] HV fuses
>
> Out of curiousity, I bought several 900 mA/5 KV fuses from an eBay Chinese
> supplier. They arrived today. They fit fine into 3AG fuse clips, but are
> about 50% longer. Internally they have a spring connected to the fuse link
> which pulls the connection apart when the fuse opens. If they work, they're
> pretty cool. and VERY inexpenisve.  I'm wondering why one couldn't parallel
> two or three of them to multiply the current rating?  Assuming they're
> reasonably well matched, so that the current divides equally among the
> fuses, it would be a very compact and inexpensive HV protection circuit. I
> would mount fuse clips on a piece of G10 circuit board and mount the
> assembly on ceramic standoffs. When one fuse opened up, all would open up,
> but replacing three fuses would cost  only a dollar or so. I'll test some of
> the fuses ( I bought twenty) to see how accurate their current rating is.  I
> have no convenient way to test their HV rating, but I'd use them only at
> 2500V in my dhomebrew amplifier.
>
> 73,
>
> Jim W8ZR
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>