I tried to use a couple 90 amp SSR relays with heat sinks in a FWD supply
and the #6 welding cable wires jumped an inch off the rack floor when
powering up as the relays went bye-bye thru the step start cycle. Now back
to the trusty 60A mercury contactors...and the EPA can kiss my as$.
Mike, K4EAR
> -----Original Message-----
> From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of Jeff
> Blaine
> Sent: Monday, February 10, 2014 4:04 PM
> To: Mike Lucas; amps@contesting.com
> Subject: Re: [Amps] Solid State Relays Again
>
> The math is a sideshow. These SSR are getting fried and I'm not sure the
root
> cause has been laid bare.
>
> Wrong relay for the application? Some sort of TVS or MOV needed?
>
> 73/jeff/ac0c
> www.ac0c.com
> alpha-charlie-zero-charlie
>
> -----Original Message-----
> From: Mike Lucas
> Sent: Monday, February 10, 2014 3:34 PM
> To: amps@contesting.com
> Subject: Re: [Amps] Solid State Relays Again
>
> On 2/10/2014 1:52 PM, donroden@hiwaay.net wrote:
> >
> > naught times naught equals naught .........
> > or has that changed with the new math ?
> >
> >
> > Don W4DNR
> >
> Naught times naught is double-naught!----- Jethro Bodine....
>
> Just wait 'till you start doing Gazintas.
>
>
> Mike W5CHR
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|