Re: [Amps] Old HP analyzer needs some repair

[Bill Turner <dezrat@outlook.com>]

ORIGINAL MESSAGE:          (may be snipped)

On 7/17/2014 11:39 AM, Pete Lancashire wrote:
> Saying that what are the reading when you put in a 50 ohm load ?
REPLY:

It reads something like -6000 ohms or some such far out number.

I guess I will pull it apart an look for the obvious. Might get lucky. :-)

Thanks for the suggestions.

73, Bill W6WRT

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps