Hello all,
Figured it was time to re-cap the PS for my Ten-Tec since they are about
25 years old. The amp hasn't been used in a while so you just know what
will happen if I DON'T re-cap it before I use it.
I really don't want to change (mechanically) the way the originals are
mounted in order to use a different, possibly more available, cap.
Looking for suggestions on sources other than the 'usual' (Digikey,
Mouser, etc...)
These caps are 400 MFD x 450 VDC, 85 degree, with screw terminals on
top. Terminals appear to be #10, with a 1/2 inch spacing. Dia is 1 3/8
inch and length is 5 5/8 inches, or so.
100 degree would be nice and the capacity can be +/-.
Any input would be helpful. I just don't want to pay $25 per cap if I
can find similar for $15.
--
73 de Steve, NR4M
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|