I have never worked with a GS-35B and it has been almost 20 years
since I had any triode experience.
I have a VHF amp with a single GS-35B and a home brew bias board
taken from the G3SEK triode board manual. Per the test procedure
described in the manual, the bias circuit is OK with adjustment
range of 27 to 50 volts.
After running filament and blower for 24 hours I wanted to see if
everything looked OK with low B+ and run it with some idling current
for 24 hours. The only supplies I have are 4000V and 1000V. With
1000V on the amp there was no sign of idling current and bias
adjustment range was 12 to 15 volts. I realize this is very low B+
for this tube but I expected to see some sign of life.
I am assuming I have a bad tube. Any other possibilities? Other
checks I can or should do?
73, Paul
--
Paul
N1BUG 160m-2m DXCC Honor Roll
WI2XTC 2200m-630m Experimental license
FN55mf ME Piscataquis County
http://www.n1bug.com
http://www.aurorasentry.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|