Hi, Manfred.
Thanks for your answer. By the way, thanks also for the many projects on
your website. I built your ESR meter last year, and right away, it
allowed me to repair several SMPS I had collected over the years!
About the MOSFET 80-meter amp: Sorry, the schematic cannot be displayed
on this list, but you can see it here:
http://lpistor.chez-alice.fr/pairf510.htm
OK, since it is a push-pull, the calculation must be done with twice the
supply voltage. I did not tnink of that.
But could it also be said, as you wrote on this page of your website:
https://ludens.cl/Electron/mosfetamps/amps.html
"When Q1 conducts at the peak of its semicycle, it will have 1.3V on its
drain, making 12.5V between Vcc and its drain. That places 12.5V on one
half of T2. Due to the tight coupling, that forces 25V to appear across
the entire T2, making Q2's drain go up to 26.3V. The primaries of T1
will see a total of 25V."
Or are these two ways to express in fact the same phenomenon?
Also, the other thing I could not understand was the high output
impedance that the author of the project claims: 42 ohms.
As Bill Turner writes in another post: "The output impedance of the amp
should be very small, close to zero and the load impedance around 50 ohms. "
That is exactly what I thought too!
Instead, this amp uses no output transformer, only a 1:1 balun. How can
this possibly work?
Vy 73
Angel HB9SLV
Le 18.07.2018 à 21:49, Manfred Mornhinweg a écrit :
Angel,
you are forgetting that this is a push-pull amplifier.
If the MOSFETs were perfect (zero saturation voltage), then the
available voltage swing would be ±13.8V for each, which equals 9.76V
RMS. Between the two drains that's twice as much, so 19.5V RMS. This
voltage applied to 50 ohm gives 7.6 watts.
Real MOSFETs do not swing fully to ground, but an IRF510 on 80 meters,
at such low power and current, gets pretty close. So the maximum
unsaturated output might be 7W. The author's spec of 5-6W seems
conservative compared to that.
In saturation that amplifier should produce significantly more power,
but of course it's no longer linear when driven that hard.
Manfred
========================
Visit my hobby homepage!
http://ludens.cl
========================
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|