Steve,
I have a Commander HF 2500, 1996 vintage, however, there are no chimneys on
top of the 3cx800s and I do not have a "solid screen".
The amplifier you're describing may be a later vintage.
I don't want to waste your time-- curious.
Thanks!
Jay, K2ZT
On Fri, Jul 27, 2018, 10:13 AM Steve Ireland <vk6vz@arach.net.au> wrote:
> G’day everyone
>
> A good friend of mine has recently acquired a Commander 2500 which is need
> of repair/rebuild after a long and hard life.
>
> On taking the amp apart, he noticed one of the neoprene chimneys on the
> (two) 3CX800 tubes was more melted than the other. He then put the amp’s
> fan on and discovered the tube with the more melted chimney was receiving
> considerably less air flow than the other, owing to a screen placed between
> the two tubes.
>
> A potential solution was to replace the solid screen with a mesh one, but
> I said it was likely that someone on this reflector had already come up
> with a solution/modification to solve this problem and I’d ask for him.
>
> It also occurred to me that someone may know where some suitable neoprene
> can be purchased, so he can make replacement chimneys for the two tubes.
> Any ideas on this would also be approached.
>
> Vy 73
>
> Steve, VK6VZ
>
> ---
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|