You might want to check with an expert on this forum to make sure your
filament supply is correct. I run a pair of 3cx800A7s and the
designer/builder stressed correct filament voltage, if I remember
correctly.
Jay, K2ZT
On Sun, Oct 10, 2021, 11:01 AM N4zed <n4zed@comcast.net> wrote:
> Has anyone here attempted the tube conversion for the Dentron MLA-2500 from
> the 8875 tube to the 3CX800A7?
>
> I have the instructions laid out by LX2KL and I have a filament transformer
> for the tubes.
>
>
>
>
>
> Thanks
>
> N4zed
>
>
>
>
>
> --
> This email has been checked for viruses by AVG.
> https://www.avg.com
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|