Thanks Jay, I have the correct filament transformer.
Ken
N4zed
From: Jay Sturtevant <k2ztdx@gmail.com>
Sent: Sunday, October 10, 2021 12:58 PM
To: N4zed <n4zed@comcast.net>
Cc: Amplifier Reflector <Amps@contesting.com>
Subject: Re: [Amps] MLA-2500 Tube Conversion
You might want to check with an expert on this forum to make sure your filament
supply is correct. I run a pair of 3cx800A7s and the designer/builder stressed
correct filament voltage, if I remember correctly.
Jay, K2ZT
On Sun, Oct 10, 2021, 11:01 AM N4zed <n4zed@comcast.net
<mailto:n4zed@comcast.net> > wrote:
Has anyone here attempted the tube conversion for the Dentron MLA-2500 from
the 8875 tube to the 3CX800A7?
I have the instructions laid out by LX2KL and I have a filament transformer
for the tubes.
Thanks
N4zed
--
This email has been checked for viruses by AVG.
https://www.avg.com
_______________________________________________
Amps mailing list
Amps@contesting.com <mailto:Amps@contesting.com>
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|