Don't think that is the case since he gets receive ok when the op switch is
off. Really needs to isolate the relay coil to see if the coil is shorted
to ground or it is wiring to the jack
Acts the same with relay cable pulled out so not the cable.
On Fri, Jul 29, 2022, 11:17 PM Jim W7RY <jimw7ry@gmail.com> wrote:
> Which would indicate that the relay in the radio has its contacts welded
> together (or its transistor or FET shorted).
>
> 73, Jim W7RY
>
>
> On 7/29/2022 4:45 PM, Mark Bitterlich via Amps wrote:
> > Try unplugging the PTT line from the amp and see if the problem goes
> away. Sounds like when you are going to "operate" on the front panel, there
> is a path to ground from the relay coil. Either inside the amp, or the PTT
> cable going to the radio. To confirm you could unsolder one side of the
> relay coil, etc. Markwa3jpy
> > -------- Original message --------From: "Ed Swiderski, KU4BP" <
> ku4bp@triad.rr.com> Date: 7/29/22 12:33 PM (GMT-05:00) To:
> amps@contesting.com Subject: [Amps] AL1200 weak receive I have a
> confusing problem with my AL1200. During operation when the stdby/oper is
> on, the received signal is very weak. Switching back to standby and the
> signal level is fine. Checked the relay and it was operating correctly.
> Engaging with 12v applied to it. With no power to the amp and a rx signal
> going through, manually engaging the relay weakens the signal. Releasing it
> and it's back to normal. Cleaned the contacts using the method described by
> W8JI on his site. Still no go. Stumped on where to look next to track this
> down. A tests on another radio produced the same results.With no power to
> the amp, I connected my RigExpert analyzer to the "RF in" and a dummy load
> to "RF out". Doing a sweep, the SWR reads around 1:1. Engaging the relay by
> hand shoots the SWR very high. Goes back down when released.That's the best
> symptoms I can give. Any suggestions would be an immense help.Thank you,Ed
> KU4BP_______________________________________________Amps mailing listAmps
> @contesting.comhttp://lists.contesting.com/mailman/listinfo/amps
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
>
> --
> Thanks and 73, Jim W7RY
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|