[Top] [All Lists]

Re: [Amps] AL1200 weak receive

To: "" <>,
Subject: Re: [Amps] AL1200 weak receive
From: "Ed Swiderski, KU4BP" <>
Date: Fri, 29 Jul 2022 20:20:48 -0400
List-post: <>
I haven't checked. am going to look at it tomorrow.

On 7/29/2022 8:10 PM, wrote:
Once again the relay is engaging in operate because the ptt line is shorted or closed by radio.  Do you see plate idle current?

Sent from the all new AOL app for iOS <>

On Friday, July 29, 2022, 6:12 PM, Ed Swiderski, KU4BP <> wrote:

    Forgive my ignorance but I thought it was to put the amp in circuit.
    Which it does because power is output. Unkeying the amp and the
    is weak. When the op switch is on.

    On 7/29/2022 5:13 PM, wrote:
    > Isn't that the way the relay is supposed to work ?? W4DNR
    > On 2022-07-29 11:30 am, Ed Swiderski, KU4BP wrote:
    >> I have a confusing problem with my AL1200. During operation
    when the
    >> stdby/oper is on, the received signal is very weak. Switching
    back to
    >> standby and the signal level is fine. Checked the relay and it was
    >> operating correctly. Engaging with 12v applied to it. With no
    >> to the amp and a rx signal going through, manually engaging the
    >> weakens the signal. Releasing it and it's back to normal.
    Cleaned the
    >> contacts using the method described by W8JI on his site. Still
    no go.
    >> Stumped on where to look next to track this down. A tests on
    >> radio produced the same results.
    >> With no power to the amp, I connected my RigExpert analyzer to the
    >> "RF in" and a dummy load to "RF out". Doing a sweep, the SWR reads
    >> around 1:1. Engaging the relay by hand shoots the SWR very
    high. Goes
    >> back down when released.
    >> That's the best symptoms I can give. Any suggestions would be an
    >> immense help.
    >> Thank you,
    >> Ed KU4BP
    >> _______________________________________________
    >> Amps mailing list
    Amps mailing list

Amps mailing list
<Prev in Thread] Current Thread [Next in Thread>