[Top] [All Lists]

Re: [Amps] AL1200 weak receive

To: "Ed Swiderski, KU4BP" <>
Subject: Re: [Amps] AL1200 weak receive
Date: Fri, 29 Jul 2022 16:13:07 -0500
List-post: <>
Isn't that the way the relay is supposed to work ??  W4DNR

On 2022-07-29 11:30 am, Ed Swiderski, KU4BP wrote:

I have a confusing problem with my AL1200. During operation when the stdby/oper is on, the received signal is very weak. Switching back to standby and the signal level is fine. Checked the relay and it was operating correctly. Engaging with 12v applied to it. With no power to the amp and a rx signal going through, manually engaging the relay weakens the signal. Releasing it and it's back to normal. Cleaned the contacts using the method described by W8JI on his site. Still no go. Stumped on where to look next to track this down. A tests on another radio produced the same results.

With no power to the amp, I connected my RigExpert analyzer to the "RF in" and a dummy load to "RF out". Doing a sweep, the SWR reads around 1:1. Engaging the relay by hand shoots the SWR very high. Goes back down when released.

That's the best symptoms I can give. Any suggestions would be an immense help.

Thank you,
Amps mailing list
Amps mailing list

<Prev in Thread] Current Thread [Next in Thread>