On 12/28/2022 2:18 PM, Paul Christensen wrote:
Even if there is NOT a neutral, it's created by design fault in some amps
and appliances. In the case of the 70/77 series amp, there's no separate
neutral conductor connection point unless the owner: (1) modifies the amp at
the power connector to isolate the blower return from the chassis; and (2)
runs 4-wire service to the amp receptacle.
Exactly correct - Ran a 70A where the neutrals were connected at an
added terminal strip, and a 4 wire cord set used. No DC continuity
between N and G on the chassis
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|