Thanks Jim
Indeed...one of those 20K resistors is open. I will replace this resistor along
with the 50 ohm and 75 ohm resistors in the step start circuit that were open
as well. Yikes. What happened?
After I install the new resistors I'll be pulling the tube out before I apply
HV just to be safe. Hopefully, some positive news later this weekend.
73 de W9LF
Get Outlook for iOS<https://aka.ms/o0ukef>
________________________________
From: Amps <amps-bounces@contesting.com> on behalf of jim.thom
jim.thom@telus.net <jim.thom@telus.net>
Sent: Tuesday, December 5, 2023 11:51 AM
To: amps@contesting.com <amps@contesting.com>
Subject: [Amps] : Re: Starting up a NEW Henry amp
CAUTION: This email originated outside of the organization. This message might
not be safe, use caution in opening it. If in doubt, do not open the attachment
nor links in the message.
: Re: [Amps] Starting up a NEW Henry amp
Lou it uses a 3CX1200D7.
There is NO adjustable tuned input. It uses 2 x un-uns in series. Henry
sez on the 3k and 8kultra ( same manual does both) if the input swr is not
good, just put up with it..and do not use the tuner in the xcvr.
Carl, watch out if one of those 20K @ 100 watt bleeders is open. The B+
will skyrocket with no load on the resonant choke input.
Jim VE7RF
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|