The IC775 doesn't have "two receivers" (with separate front ends) like some
other models. Thus putting the second VFO on a separate band will give
poor (or no) sensitivity on that band.
73, de Hans, K0HB/W7
> [Original Message]
> From: Tony Rogozinski <trogo@telegraphy.com>
> To: <cq-contest@contesting.com>
> Date: 2/15/2008 9:37:46 AM
> Subject: [CQ-Contest] IC775 Question
>
> If I use the IC775 in "split" mode on one band then switch to another
band if I don't "equalize" VFO A and VFO B to be on
> the same "new" band I find that signal levels are down several "S Units".
Is or should this be normal? I would think not
> but my technical knowledge in this area is minimal.
>
> Thanks for any answers or suggestions.
>
> Tony W4OI/HK1AR
> _______________________________________________
> CQ-Contest mailing list
> CQ-Contest@contesting.com
> http://lists.contesting.com/mailman/listinfo/cq-contest
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|