CT-User
[Top] [All Lists]

Re: [ct-user] K3 questions

To: ct-user@contesting.com
Subject: Re: [ct-user] K3 questions
From: Ken Wolff <ken@k1ea.com>
Date: Thu, 21 Aug 2008 18:25:24 -0400
List-post: <ct-user@contesting.com">mailto:ct-user@contesting.com>
Damn. I was hoping somebody would send me a K3 to develop the code.

- Ken

Ed K1EP wrote:
> I have used CTWin and CTDos with my K3 with USB (in Win) with no problems.
>
> At 8/21/2008 02:20 PM, Dennis Vernacchia wrote:
>   
>> Try selecting Kenwood TS-50 or another Kenwood Xcvr.
>> It works for CTDOS
>> and worth a try for CTWIN
>>
>>
>> 73, Dennis N6KI
>> Sandy Eggo
>>
>> On Thu, Aug 21, 2008 at 11:03 AM, Don Richards <donsay2@cox.net> wrote:
>>
>>     
>>> I suppose it is useless to ask the following questions since it appears
>>> CTWin is no longer being supported but, just in case, here is my
>>> question:  Is there a way to select K3 as the transceiver being used as
>>> well as its baud rate?  Since most new computers come without serial
>>> ports but with USB ports, is there a problem in using a USB to RS-232
>>> converter and selecting a port number relative to those listed in the
>>> CTWin software setup?
>>> W7UPF  donsay2@cox.net
>>> _______________________________________________
>>> CT-User mailing list
>>> CT-User@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/ct-user
>>> CT on the web:  http://www.k1ea.com/
>>>
>>>       
>> _______________________________________________
>> CT-User mailing list
>> CT-User@contesting.com
>> http://lists.contesting.com/mailman/listinfo/ct-user
>> CT on the web:  http://www.k1ea.com/
>>     
>
> _______________________________________________
> CT-User mailing list
> CT-User@contesting.com
> http://lists.contesting.com/mailman/listinfo/ct-user
> CT on the web:  http://www.k1ea.com/
>
>   
_______________________________________________
CT-User mailing list
CT-User@contesting.com
http://lists.contesting.com/mailman/listinfo/ct-user
CT on the web:  http://www.k1ea.com/

<Prev in Thread] Current Thread [Next in Thread>