[Karlnet] Bridging between interfaces A & B

["admin " <admin@mail.warpspeedinternet.ws>]

   For any of you using an AP1000 with TC ISP Base upgrade:
Interface A is TC satallite PtP with a ROR in PtP master mode. The interface 
moniter shows traffic with no loss, signal is good. Interface B is 802.11b. 
From my laptop I can ping the AP1000 but not the ROR. The IP numbers are in the 
same range, with in one digit of each other. Since there is traffic between the 
AP and ROR, I assume my setup is causing a lack of packet transfer between the 
two interfaces. Would anyone care to share their setup?
TIA,


--
Eric L. Johnson
WarpSpeed Internet
1-361-563-3742
--