Norm
Actually the prism II card is in the cpe (rg1000), I’m thinking it might
be a bad cable to the antenna, not sure as I can do a wireless link test from
the AP to the CPE, but I can’t ping the cpe or access it in any other method
Dan Metcalf
Wireless Broadband Systems
dan.metcalf@wbsysnet.com
781-658-2075
www.wirelessbroadbandsystems.com
-----Original
Message-----
From: Norm Young
[mailto:npyoung@applegatebroadband.net]
Sent: Sunday, May 26, 2002 10:36
PM
To: karlnet@WISPNotes.com
Subject: Re: [Karlnet] v4.02 w/
200mw cards
Dan,
I saw
something like this when I installed a PRISM II 100mW card in a
AP-1000. Seriously asymmetrical signal strengths. For
instance, the signal at the AP would say I was at -80dB, but the signal at the
CPE would say -70dB, or higher. Swapped the card into my PtP link, again
using the AP, and everything was great. Very strange. It's been
working really well for about a month now.
Now
that I think about it, I seem to remember that Tony said that the AP needed to
be booted once w/o the PRISM II card in it, then the card hot-slotted to make
it work. One of these days (soon), I'm going to try and swap that PRISM
II card back into the PtMP slot and see if I see the same problem.
Please
report what you find.
Hope
the above rambling helps...
Norm
-----
Original Message -----
To: 'karlnet@WISPNotes.com'
Sent: Saturday, May 25, 2002
12:07 PM
Subject: RE:
[Karlnet] v4.02 w/ 200mw cards
I have an rg1000 w/ v4.02
and a 200mw card, tested it out
and it seemed ok, installed it at a customers location and something isn't
good.
I see -94 dBm on the cpe
side and -76 dBm at the AP. Which
is 18dBm's difference, and there should only be a 8dBm difference and the unit
doesn't pass traffic.
Anybody see this before?
Dan Metcalf
Wireless
Broadband Systems
dan.metcalf@wbsysnet.com
781-658-2075
www.wirelessbroadbandsystems.com