> -----Original Message-----
> From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
> Behalf Of Nate McLain
> Sent: Friday, July 12, 2002 10:29 PM
> To: karlnet@WISPNotes.com
> Subject: [Karlnet] Proper CPE Config?
>
>
> Ok guys... I have a question..
> What is the proper config for a user that you want to run DHCP & Outgoing
> NAT.
> Public IP: 207.193.79.100
> Subnet: 255.255.255.0
> Gateway: 207.193.79.254
>
> Internal Radio IP: 192.168.100.254
> Private IP: 192.168.100.100
> Subnet: 255.255.255.0
> Gateway: 192.168.100.254
>
> Now the real question is... If you want to enable Outgoing &
> Incoming Nat, &
> DHCP do you have to Enable Bridging to get that to work? We have about 19
> locations that have Outgoing/Incoming & DHCP enabled and DON'T
> have Bridging
> or IP Routing Enabled...
> Is that the way it should work?? Because the last 2 customers we ran into
> some problems..
> On one of the installs we had to Enable Bridging and give the PC
> a public IP
> to get it to work.
> The one yesterday we had to Enable Bridging, Enable Outgoing NAT
> & DHCP. And
> everything started working...
> Im not sure if anyone else has seen this.
> I guess I would like to hear from Doug or Kevin from Karlnet
> about this.....
> What is the proper way to setup the CPE.
> We use RG-1000 or RG-1100 with SR-4000's installed.
> We use Outgoing NAT & DHCP so that the user doesn't have to setup a IP or
> know anything about it.
>
> Anyway... has anyone else seen this?
> Or how do you setup your RGs to do this??
> What is the correct way??
>
> Nate McLain
> Chisholm Trail Networks LLC
> nate@ctrail.net
> http://www.ctrail.net
> 580-401-6656
> 405-880-2795
>
> "Bringing broadband Internet Access to over
> 20 Communities in North Central Oklahoma!!"
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
>
|