Mark, if you look on the card, there's some lettering by the connectors. (I
& II) The proper connection is the one marked "I", I've found.
Norm
----- Original Message -----
From: "Mark McKibbin" <mark@team.dcsi.net.au>
To: "Karlnet Mailing List" <karlnet@WISPNotes.com>
Sent: Wednesday, October 08, 2003 12:05 AM
Subject: RE: [Karlnet] Some details about the Blackbird card
I am playing with the KN50 and the radio has two mc card connectors
which one to use? I'm getting crappy results either way and this is
still indoors, any help would be apprieciated.
Regards
Mark McKibbin
DCS Internet
64 Queen St
Warragul
Victoria 3820
Australia
www.dcsi.net.au
mark@team.dcsi.net.au
Ph. 1300 665 575 (Help Desk)
Ph. +61 356 241 120 (Direct)
Fx. 1300 556 595
Fx. +61 356 220 617
-----Original Message-----
From: Kevin Knuth [mailto:kknuth@karlnet.com]
Sent: Wednesday, October 08, 2003 2:09 PM
To: 'Karlnet Mailing List'
Subject: RE: [Karlnet] Some details about the Blackbird card
That information is NOT correct.
We are selling this current batch with an AGERE HERMES I chipset card,
which is the same as a "gold" card.
The board CAN support the 100mw cards, BUT we have NOT added that
support yet! ( SO DON'T TRY IT ).
Kevin
**************************************
Kevin R. Knuth
Business Development Manager
North America
260-424-9690 Regional Office
614-822-5275 Corporate Office
kknuth@karlnet.com
www.karlnet.com
**************************************
-----Original Message-----
From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com] On Behalf Of Bob Hrbek
Sent: Tuesday, October 07, 2003 9:37 PM
To: Norm Young; Karlnet Mailing List
Subject: Re: [Karlnet] Some details about the Blackbird card
Any truth here Karlnet?
----- Original Message -----
From: "Norm Young" <lists@applegatebroadband.net>
To: "Karlnet Mailing List" <karlnet@wispnotes.com>
Sent: Tuesday, October 07, 2003 10:10 PM
Subject: [Karlnet] Some details about the Blackbird card
> I was installing a customer today using a KN-50 (Blackbird) card and I
found
> out a few things on the way. The PCMCIA card included with the SBC
seems
> to be compatible with Orinoco (substituted a silver in to try). The
> RF connectors are the same, but the output power seems to be
> different. The included card is probably 100mW, I'd guess, as opposed
> to the silver's
30mW.
> Also, the rx sensitivity is not as good as a silver.
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|