This is not a NA only problem, but maybe your responses will fix ALL the =
issues.
I just got a loaded P/133 w/4 COM ports. COM1 is trackball COM2 =
internal fax/modem COM3 goes to my Kenwood for controlling it and COM4 =
is for my PK88 TNC. As an aside, NA10 and the TNC (as well as other =
control programs work FB on my 286 w/just COM1 and 2. Also these =
problems occur whether I use MS-DOS prompt from Win95 or shut down the =
computer and restart in MS-DOS configuration. If it means anything, =
COM4 uses IRQ9.
The TNC either doesn't respond at all or responds incorrectly. With =
Procomm+, there's no response to the "*". With PC PacRatt, it starts =
downloading and stops. The ROM Release information is weird (I plan to =
call AEA and see if they can identify the problem based on this data). =
With NA10, PKINIT makes the controller CMD LED light up, but there's no =
further response.
Everything else works with NA10 (so far). COM3 band changes as the =
manual says it should and LPT2 operates the voice keyer and CW messages =
properly.
Any ideas?
Thanks and 73,
Bob AA0CY
(aa0cy@robertwanderer.gardnerville.nv.us)
--
Submissions: na-user@ve7tcp.ampr.org
Administrative requests: na-user-REQUEST@ve7tcp.ampr.org
Questions: owner-na-user@ve7tcp.ampr.org
|