NA-User
[Top] [All Lists]

[NA-User] Top Ten Devices DXD

To: <na-user@contesting.com>
Subject: [NA-User] Top Ten Devices DXD
From: N5RP at pdq.net (Bob, N5RP)
Date: Sun Jul 13 17:44:10 2003
Will look into it.
Maybe, just maybe.
All else is sweet, so I hope it is as simple as what you suggest for 
looking into.

Details later !!

Bob, N5RP
=========================>


At 17:11 7/13/03 -0400, k9tm wrote:
>Bob
>
>I purchased two of these at Dayton and one of them had this same problem.
>What I found was that where the d-shell for the 25pin parallel port attaches
>to the pc-board... the NA pin was not soldiered.  Therefore, it would not
>work.  You may want to check that.  Once I soldiered it, no problems.  You
>will have to see the bottom side of the board to know.
>
>Not sure if you feel comfortable taking it apart or not but it sounds like
>NA is OK and you said you have the jumpers set.  Not sure what your tech
>level is?  If you need any help on where to look, let me know.
>
>I attached a PDF picture of the problem I had.
>
>73 Tim K9TM
>
>
>
> > -----Original Message-----
> > From: na-user-bounces@contesting.com
> > [mailto:na-user-bounces@contesting.com]On Behalf Of Bob, N5RP
> > Sent: Sunday, July 13, 2003 8:45 AM
> > To: na-user@contesting.com
> > Subject: [NA-User] Top Ten Devices DXD
> >
> >
> > Just got this Top Ten devices DX Doubler SO2R box all wired,
> > and it seems to be running well except ............
> >
> > LPT will not drive the switching from radio 1 to radio 2 in automatic
> > positions.
> > The software switches from radio 1o to radio 2, as it has always done.
> > The com ports read the radios properly as to band, mode, freq, etc.
> >
> > But, in switching from radio to the other as far as transmitting is
> > concerned..............
> > Only way to accomplish same is from radio 1 to radio 2 is in manual mode.
> > In auto mode, the box wants to only listen and key radio #1.
> >
> > All else works well.
> >
> > Any tricks learned or experienced by others in making the LPT do radio
> > switching functions for transmit and receive ?
> >
> > Running version 10.58, and all is configured properly in the config.exe
> > program.
> >
> > Thanks,
> >
> >
> > Bob Perring
> > ...........................................
> > Amateur Radio Station  N5RP
> > mailto:N5RP@pdq.net
> >
> > _______________________________________________
> > NA-User mailing list
> > NA-User@contesting.com
> > http://lists.contesting.com/mailman/listinfo/na-user

Bob Perring
...........................................
Amateur Radio Station  N5RP
mailto:N5RP@pdq.net
N5RP Station Page: http://web2.airmail.net/perring/station.html
<Prev in Thread] Current Thread [Next in Thread>