RTTY
[Top] [All Lists]

Re: [RTTY] FT1000D tuning speed problem/question

To: "Van K7VS" <wa7fab@cdsnet.net>,"RTTY Reflector" <rtty@contesting.com>
Subject: Re: [RTTY] FT1000D tuning speed problem/question
From: Jeff Stai WK6I <wk6i@twistedoak.com>
Date: Sun, 15 Jan 2006 10:45:42 -0800
List-post: <mailto:rtty@contesting.com>
At 08:59 AM 1/15/2006, Van K7VS wrote:
>The older 90's model, seems to have a 
>slow tune rate about 2.5 khz per revolution of the knob and a fast rate of 
>about 10 khz per revolution of the knob depending on how fast you turn the 
>knob.  The newer model 2000+ purchase date has only ONE tuning rate which is 
>10 khz per full rotation of the tuning knob which makes tuning 170 cycle 
>shift signals very difficult.  Did Yaesu change the opto-coupler system on 
>their ft1000's somewhere along the line or do I have a problem with my unit?

You didn't say whether you were the original owner, but it sounds like 
the older unit has either been modified by a previous owner somehow or 
has a problem that manifests itself as a slower tuning rate. I have an 
older and a newer as you do and 10KHz per rotation is what they both do.

I am not aware of a specific mod to slow the tuning rate down, but 
perhaps a change of encoder did the trick. You might pull the front 
panel on each and see what differences you can find.

I have been using my 2000 vintage 1000D since I bought it new, and 
acquired the older one a couple years ago. I have been using both of 
them so much that I guess I am used to the tuning rate. Here are some 
suggestions that may help:

1. If you are running writelog, and you are using a mouse with a 
center wheel, turning the wheel tunes the active radio! I discovered 
this by accident a little while back so I don't know when they added 
it. The rate is 10Hz per wheel click.

2. Use RIT+XIT both on to fine tune (I don't do this but it would seem 
it would work?)

3. What I do most of the time is just rest my hand on the table 
underneath the knob and use my index finger to gently feather the 
knob. I guess I have just done this enough that the practice has 
worked. I find that I can snap the knob to the right place by ear. I 
don't consider that I have any innate talent for this, I just do it 
because I have to.

Just by the way, I added the InRad roofing filters to both rigs, and 
the improvement has been dramatic. I have found that 'splatter' of 
nearby stations doesn't bother me anywhere near as much as it used to, 
and this includes robots. And as a result I seldom if ever reach for 
the shift knob anymore.

Hope some of the above is helpful - jeff wk6i


--
Jeff Stai               jds@twistedoak.com
Twisted Oak Winery      http://www.twistedoak.com/
Rocketry Org. of CA     http://www.rocstock.org/
Amateur Radio           WK6I ~ Calaveras County, CA 


_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

<Prev in Thread] Current Thread [Next in Thread>