Joe,
I have connected the speaker jack on the Signalink to speaker out on the
radio and I get print on the screen. Also the XY scope and the FTT are
present and I can copy a signal. I feel now that the problem is in the PSK
jack on the back of the radio. That is the jack that I have used before and
that Signalink says to use. I will look at the pot to see how it is set. I
am looking for someone with a scope to test the jack. Thanks for the advice.
As soon as I get RTTY working I will make a post on this reflector.
Dick - KS0M
Richard C. "Dick" White
Fulton, Missouri 65251 U.S.A.
whiter26@sbcglobal.net
Amateur Radio Station: KS0M
-----Original Message-----
From: rtty-bounces@contesting.com [mailto:rtty-bounces@contesting.com]On
Behalf Of Joe Subich, W4TV
Sent: Wednesday, May 16, 2012 8:11 PM
To: rtty@contesting.com
Subject: Re: [RTTY] FW: reply to W7AY
Dick,
Signalink has a 3.5mm jack connected in parallel with the audio input.
Connect a 3.5mm to 2.5mm stereo audio cable from the "AF Out" jack on
your MK V to that jack ... it will provide an alternate source of the
fixed level (Main and Sub Rx in stereo but Signalink will ignore the
sub RX audio). If you can then receive RTTY, it will indicate that
the Audi out on your RTTY jack is bad (or the level pot is turned down
too far). If you can't receive anything using the alternate connection
the problem will be in the Signalink or your windows configuration.
73, ... Joe, W4TV
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|