Re: [RTTY] Changing MMTTY to 75 baud for the BARTG 75 Sprint

[W0MU Mike Fatchett <w0mu@w0mu.com>]

K3 users remember to change the FSK speed.  Hold the APF key for a 
second.  Make sure you do this for each band.
Mike W0MU

On 4/26/2014 9:05 PM, Don Hill AA5AU wrote:
> Information on running 75 baud with MMTTY, 2Tone and WriteLog here:
>
> http://rttycontesting.com/75baudrtty/75baudrtty.html
>
> 73, Don AA5AU
>
> -----Original Message-----
> From: RTTY [mailto:rtty-bounces@contesting.com] On Behalf Of Bill Turner
> Sent: Saturday, April 26, 2014 9:22 PM
> To: RTTY group
> Subject: [RTTY] Changing MMTTY to 75 baud for the BARTG 75 Sprint
>
> The BARTG 75 baud Sprint contest is tomorrow.
>
> There are the four steps to change MMTTY to 75 baud:
>
> I use FSK only, but I assume this applies to AFSK as well. If not, please let 
> me know.
>
> 1. Start MMTTY and go to Options>Setup MMTTY and select the Demodulator tab.
> 2. At the bottom, UN-check the box that says "Fixes 45.45 baud".
> 3 Go to the Decode tab and change the baud rate to 75.
> 4. Click OK.  Do not skip this step or changes will not be saved.
>
>
> This is a short contest - just four hours but lots of fun. Rules at:
>
> http://bartg.rsgbcc.org/cgi-bin/hfreadcal.pl
>
> See you there!
>
> 73, Bill W6WRT
>
>
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty